Panasonic DP-7000 - Manual (Page 14)

xii
Be sure to switch Off and unplug the machine
before accessing the interior of the machine for
cleaning, maintenance, or fault clearance.
Access to a live machine's interior can cause
electric shocks.
When the machine is not used over an extended
period of time, switch it Off and unplug it. If an
unused machine is left connected to a power
source for a long period, degraded insulation
can cause electric shocks, current leakages, or
fire.
Once a month, unplug the machine and check
the Power Cord for the following:
The Power Cord is plugged firmly into a
receptacle.
The plug is not excessively heated, rusted, or
bent.
The plug and receptacle are free of dust.
The cord is not cracked or frayed.
If you notice any unusual conditions, contact your
local authorized Panasonic service representative.
This machine has a ground fault interrupter. Once
a month, check the protection circuit for correct
operation using the following procedure. If the
circuit does not operate, an electric shock can
occur on a poorly grounded component. If you
notice any unusual conditions, contact your local
authorized Panasonic service representative.
Press the power switch to the " " position.
Press the test button below the breaker
switch with the tip of a ball pen. When the
breaker switch is turned from " " to " ",
the circuit is OK.
Turn the breaker switch, then the power
switch to the " " position.
Do not attempt to rework, pull, bend, chafe, or
otherwise damage the Power Cord. Do not
place a heavy object on the cord. A damaged
cord can cause fire or electric shocks.
Never touch a Power Cord with wet hands.
Danger of electric shock exists.
Stop operation immediately if your machine
produces smoke, smell, excessive heat, or
unusual noise, or if water is spilt onto the
machine. These conditions can cause fire.
Immediately switch off and unplug the machine,
and contact your local authorized Panasonic
service representative.
If the Power Cord is broken or insulated wires are
exposed, ask your local authorized Panasonic
service representative for a replacement. Using a
damaged cord can cause fire or electric shocks.
To prevent fire or electric shocks, your machine
must be grounded. If in doubt, contact your local
authorized Panasonic service representative.
Never connect the ground wire to any of the
following:
Gas pipe, which can be ignited and explode
Telephone line ground wire or lightning rod,
which can draw an excessive electric current
if hit by lightning
Water faucet or pipe whose electrical
conductivity is broken by a non-metal part
Do not unplug the machine while it is on.
Unplugging a live connector can deform the plug
and cause a fire.
When unplugging the machine, grasp the plug
instead of the cord. Forcibly pulling on a cord
can damage it and cause fire or electric shocks.