Panasonic DP-7000 - Manual (Page 28)

6
1
1-2 Switching On and Off
If the breaker trips repeatedly,
contact your local authorized
Panasonic service representative.
Check the Ground Fault Interrupter
once a month to ensure that it works
correctly.
Power requirements and ground
connection
of Safety Notes for an
explanation on the Ground Fault
Interrupter.
Switching On and Off
Switch On the power before operating the copier.
This section will show you how to switch the copier On/Off.
The Breaker Switch is
normally set to the "I" position.
However, when it is not used
for an extended period of time
or when it is to be relocated,
switch it to the "O" position.
Switching On the Power
Turn the power switch to the
" " position.
The power is switched On.
After a while, the default screen
appears on the display.
You can change the default screen
from the Basic Features screen to
any other screen and the new
screen will be displayed.
The machine will be in the Ready
mode approximately three minutes
after the power is switched On.
When the Power Saver mode is On,
the display will still be Off and the
Power Saver indicator will be On.
Breaker Switch