Precor C932 - Manual (Page 10)

page 10
C O M M E R C I A L P R O D U C T S D I V I S I O N
You do not need any special knowledge or experience to set up the treadmill.
However, you will need assistance during assembly.
INSTALLATION REQUIREMENTS
Follow these installation requirements when installing the treadmill. If you do not
install the treadmill according to the following guidelines, you could void the Precor
limited warranty.
• Set up the treadmill on a solid, flat surface. Unpack and assemble the
treadmill close to where you plan to use it. Make sure that the surface under
the unit is smooth and level. A level unit is required for the user’s safety and
proper operation.
• Provide ample space around the unit. Open space around the unit makes
for a safer mount and dismount.
• Fill out and mail the limited warranty card. The serial number can be found
on the shipping container or on the label near the power receptacle. Write the
serial number onto the Precor limited warranty card found inside the back
cover of this manual and in the
Obtaining Service section on page 7.
• Use the appropriate voltage, dedicated circuit, and grounding as speci-
fied on the treadmill. A 20 amp dedicated circuit is recommended.
ASSEMBLY INSTRUCTIONS
To assemble the treadmill, take the following steps.
1. Obtain adult assistance. Have your assistants help place the shipping carton
close to the location where you plan to use the treadmill. Break down the side
walls of the shipping carton so that they lie flat. Remove the loose contents.
2. Make sure that the power switch is OFF. Check the ON/OFF power switch
on the front of the treadmill. Place the switch in the O (OFF) position. Make
sure that the treadmill is not plugged into a power source.
Setting Up the Treadmill
Diagram 3
Lift rear by placing
hands on opposite
sides of the cross
brace that is found
under the rear cover.
Lift the rear of the
unit and roll it to its
assembly location.
End cap