Precor C932 - Manual (Page 27)

page 27
C O M M E R C I A L P R O D U C T S D I V I S I O N
The SmartRate ® and Heart Rate system is standard equipment. The heart rate
receiver is factory-installed in the display console. To actively view the SmartRate ®
and heart rate displays, a user must wear a POLAR ® chest strap, face the dis-
play console, enter his or her age (during the Setup prompts), and begin a course.
The user’s heart rate is transmitted from the chest strap to the receiver inside the
console and appears on the display. A blinking segment approximates the user’s
heart rate and shows which zone the heart rate is in: weight loss or cardiovascular.
Important: During a course, a user’s heart rate must be above 40 beats per
minute before the segment begins to blink. Note that pressing QuickStart at the
PRECOR banner causes the SmartRate
® display feature to be inactive.
SETUP MODE AND PROMPTS
The PRECOR banner is the “starting point” when a user begins a workout. If the
banner does not scroll across the display, press the RESET key. If the display
appears blank, make sure that the treadmill is turned ON. Press the ON/OFF [I/O]
switch located at the front, near the power receptacle, to ON.
PRECOR banner: From the PRECOR banner, a user presses the SELECT key
to access the Setup mode which lets a user determine the course, workout time,
weight, and age parameters as described below.
Note: Key presses to the INCLINE ▼▲ or SPEED ▼▲ keys are ignored when the
banner is being displayed. Refer to page 30 for more information about the keypad.
MANL: The course prompt, MANL, indicates that the C932 is ready to accept
course entries. To help a user determine which course they want to use, the
course names and profiles appear on the display console label. The
▼ and ▲
keys let a user scroll through the available courses. The display presents the
abbreviated name of the course. To choose the selection being displayed and
continue in Setup mode, press SELECT. (Refer to
The Setup Mode and the
QuickStart Feature on page 28.)
Note: Depending on the course that is selected, a user may be prompted for
other information. Refer to
C932 Courses on page 40.
XX MIN: Acceptable entries at the workout time prompt range between NOLIM (zero)
and 99 minutes. Use the
▼ and ▲ keys to change the selection. If the club allows it
and a user wants to work out indefinitely, they can choose NOLIM. A cool-down
period will not be appended to the course. Note that the Weight Loss course has a
preset time limit so a user will not be prompted for a workout time when they choose
WTLS. A user cannot workout indefinitely in the Weight Loss course.
To continue in Setup mode, press SELECT.
Important: The club has the option to set limits on course duration and cool down
and pause time. Refer to Club Information on page 20.