Precor C932 - Manual (Page 29)

page 29
C O M M E R C I A L P R O D U C T S D I V I S I O N
Table continued...
If QuickStart is pressed at the: The following occurs:
Weight prompt The weight (150LB or 68KG) that appears
on the display becomes the designated weight
that the C932 uses to compute various cal
culations. A user can change the display from
1 through 999 using the
▼ or ▲ keys.
Age prompt The age prompt (AGE 0) that appears on
the display becomes the designated age that
the C932 uses for SmartRate
® system. A
correct age entry between 1 and 99 is very
important if a user plans to use the heart
rate characteristics of the treadmill. The
QuickStart key acts the same as the
SELECT key at this point because the user
has answered all the Setup prompts.
CENTER DISPLAY DURING A WORKOUT
The PRECOR banner, setup prompts, course profiles and feature selections
appear in the center display. Prior to working out, prompts guide the user through
the Setup mode. Refer to
Setup Mode and Prompts.
Once a user begins a workout, the SCAN LED is lit indicating that all highlighted
features (PROFILE, TIME, DISTANCE, etc.) will appear consecutively on the
display. A user can change what features are scanned by pressing the SELECT
key. Refer to
Changing the Display Features Using the SELECT Key on page 34.
The following describes the information that can appear in the display.
PROFILE: At the beginning of a course, the profile appears on the right side of
the display and corresponds to the course that has been selected. As a user
proceeds through the workout, a blinking column indicates his or her position in
the course. The height of the column indicates the level of incline. Every time the
incline changes by several sequential levels (up or down) the height of the col-
umn changes by one cell.
TIME: A time (0:00) display appears when a user begins working out. TIME ap-
pears in minutes and seconds. However, should a user exceed 60 minutes (dur-
ing a single workout), the TIME display converts to hours and minutes. Most
often, the TIME display shows the amount of time remaining in a workout.
DISTANCE: The distance that a user has traveled appears (00.00) once a work-
out begins. Distance can appear in miles or kilometers. If the user wishes to
change the display, they will need to contact the club manager or owner. Refer to
the instructions found in
Club Information on page 20.