Paxar Sierra Sport2 9460 - Manual (Page 40)

3-12 System Administrator’s Guide
For the tear edge:
1. Remove supplies or rewind the supplies enough to make sure there is
nothing under the sensor.
Note: The sensor needs to calibrate without supply under the sensor.
2. Close the supply door.
3. Press A under ↵ to continue.
SUCCESSFUL
↵ X
Note: If you see a "FAILED" message, call Service.
4. Press A under ↵ or press A under X to return to the Demand Sensor
menu.
5. Press F to return to the Printer menu.
6. Load supplies.
Tear edge
On-demand sensor