Panasonic DMC-TS1 - Manual (Page 51)

51
VQT1Z45
Advanced (Recording pictures)
∫ Shutter speed for each flash setting
¢1 It may vary depending on the [MIN. SHTR SPEED] setting (P90).
¢2 When Intelligent ISO is set (P82)
• ¢2: The shutter speed becomes a maximum of 1 second in the following cases.
– When the optical image stabilizer is set to [OFF].
– When the camera has determined that there is little jitter when the optical image stabilizer is
set to [MODE1], [MODE2] or [AUTO].
• In Intelligent auto mode, shutter speed changes depending on the identified scene.
• The shutter speed for [SPORTS], [SNOW], [BEACH & SURF] and scene modes will be
different from above table.
Note
• If you bring the flash too close to an object, the object may be distorted or discolored by the
heat or lighting from the flash.
• When you take a picture beyond the available flash range, the exposure may not be adjusted
properly and the picture may become bright or dark.
• When the flash is being charged, the flash icon blinks red, and you cannot take a picture even
when you press the shutter button fully. When [AUTO LCD OFF] is set, the LCD monitor
turns off and the status indicator lights.
• The white balance may not be properly adjusted if the flash level is insufficient for the subject.
• When the shutter speed is fast, the flash effect may not be sufficient.
• It may take time to charge the flash if you repeat taking a picture. Take a picture after the
access indication disappears.
• The red-eye reduction effect differs between people. Also, if the subject was far away from the
camera or was not looking at the first flash, the effect may not be evident.
Flash setting Shutter speed (Sec.) Flash setting Shutter speed (Sec.)
‡
1/30 to 1/1300th ¢1
1 to 1/1300th ¢1
1 or 1/4th to 1/1300th ¢2
‰
Œ
VQT1Z45~Body1_mst.fm 51 ページ ２００９年１月２９日 木曜日 午後９時４９分