Panasonic PANAFAX UF-333 - Manual (Page 68)

64
Receiving Documents
Setting the TAM Interface Mode
Change Fax Parameter No. 16 (OUT MODE) to 2: TAM I/F. (see page 36)
OUT
Confirm that the lamp is ON and the display is as shown
to the right.
Operation of TAM Interface Mode
When your TAM and Fax receives an incoming call, the TAM always answers the call first
and then the TAM plays the OGM (Outgoing Message) recorded in your TAM to the calling
station. During the time the TAM is answering the call, your fax machine will be monitoring
the line to distinguish whether it is a voice or fax call.
Your machine will switch the line to the
fax and then begin to receive the
documents immediately from the
calling station. Your TAM continues to record a
message (ICM) after playing the
OGM. 2
a
2
b
If it is Fax call, If it is a Voice call,
Sample of OGM
Hello, this is Smith. Sorry I am unable to take your call. Please leave your message after the
beep or if you are calling to send a fax, press the asterisk button twice on your touch tone
phone now and start your machine. Thank you for calling.
Silent Detection Mode
Enables your Fax machine to switch to the Fax Mode when receiving from units that do not
send fax signal (short beep) and prevents your TAM from recording blank (long silence)
incoming message.
To activate this feature,
1. Change Fax Parameter No. 20 (SILENT DET.) to 2 : Valid. (see page 36)
2. Set the time length of the OGM recorded in your TAM with the Fax Parameter No. 19
(OGM LENGTH). (see page 36)
[We recommend to set the time length 5 or 6 seconds longer than the actual time length of the OGM.]
04004000002
04004020008
04004060039
04004060040
04004020009
04004060022
04004060023
04004990001
04004990006
SEP-12-1999 15:00
RCV MODE=FAX/TAM 00%
1
2
1