Panasonic PT-AE3000E - Manual (Page 32)

32 -
E
NGLISH
Settings
PICTURE menu
Depending on the projection environment, you can use
these preset parameter settings to optimise image
projection. Press I H to cycle through the options.
You can adjust the contrast of the projected image.
Adjust the BRIGHTNESS in advance if necessary.
Setting range: -64 to +64
You can adjust the brightness of the projected image.
Setting range: -32 to +32
You can adjust the colour saturation of the projected
image.
Setting range: -32 to +32
When COMPUTER signal is connected, only available
with the following signals.
1 125 (1 080)/60i 1 125 (1 080)/50i
1 125 (1 080)/60p 1 125 (1 080)/50p
You can adjust the skin tone in the projected image.
Setting range: -32 to +32
When COMPUTER signal is connected, only available
with the following signals.
1 125 (1 080)/60i 1 125 (1 080)/50i
1 125 (1 080)/60p 1 125 (1 080)/50p
You can adjust the sharpness of the projected image.
Setting range will vary according to the selected input
signal.
PICTURE MODE
NORMAL CINEMA3
DYNAMIC
CINEMA2
COLOUR1
COLOUR2 CINEMA1
NORMAL
Setting for a general image, such
as sports programme or TV
games
DYNAMIC Bright and sharp setting
COLOUR1
Setting for HDTV standard in ITU-
R BT. 709 and colour temperature
6 500 K at the default setting of
the PICTURE menu items.
COLOUR2
Setting for DCDM standard
(SMPTE431-2) and colour
temperature 6 300 K at the
default setting of the PICTURE
menu items.
CINEMA1
Setting tuned by top Hollywood
colourists
CINEMA2
Deeper and more rich colour
setting
CINEMA3 Vivid and crisp colour setting
NOTE:
• It may take for a while until the selected mode is
stabilised.
Remote control Control panel
See “Navigating through the MENU” on page 29.
See “Main menu and sub-menu” on page 30.
CONTRAST
BRIGHTNESS
COLOUR
TINT
SHARPNESS
Higher Lower
Brighter Darker
Darker Lighter
More
greenish
More
reddish
More
sharp
Less
sharp