Panasonic PT-AE3000E - Manual (Page 33)

PICTURE menu
E
NGLISH - 33
Settings
You can adjust the white balance of the projected image.
Setting range: -6 to +6
You can switch automatic adjustment of the lamp and
the lens iris on/off.
ON: Automatic adjustment
OFF: No adjustment
You can monitor whether or not the luminance level of
the input signal is in the recommended range by
displaying it in the waveform monitor. If the waveform is
not in the range, adjust it for the best quality. See
“Adjusting the signal condition with a waveform” on
page 24.
1. Press F G to move to the required waveform
style.
2. Press ENTER to select.
The WAVEFORM MONITOR will be displayed.
See “Adjusting the signal condition with a waveform”
on page 24.
J MONITOR POSITION
When the FULL SCAN is selected, press F G I
H to adjust the position of the monitor.
See “Adjusting the signal condition with a waveform”
on page 24.
J AUTO ADJUST
You can switch on/off the automatic adjustment
system in each items.
1. Press F G and select the required item.
2. Press I H and switch on/off.
3. Press F G and select AUTO and press ENTER.
The confirmation screen will be displayed.
4. Press I H and select OK.
5. Press ENTER.
You can perform image adjustment for some PICTURE
menu items while displaying a certain area of the frozen
image in a split window.
Q SPLIT ADJUST MODE
Select the required split style from NORMAL and
REVERSE in the SPLIT ADJUST MODE menu.
NORMAL
REVERSE
COLOUR TEMPERATURE
DYNAMIC IRIS
WAVEFORM MONITOR
NOTE:
• When the WAVEFORM MONITOR is set to OFF, the
AUTO ADJUST is not displayed.
• The waveform of the WAVEFORM MONITOR will not
be displayed correctly with a noisy equipment or
source.
• The WAVEFORM MONITOR adjusts the signal level
based on the reference signal which consist of 0% and
100%. The over scanned reference signal which runs
off the edge of the screen, below 0% or over 100%
signal level will not be adjusted correctly.
More
bluish
Less
bluish
OFF
FULL SCAN(Y)
FULL SCAN(R)
FULL SCAN(G)
FULL SCAN(B)
SINGLE LINE SCAN(Y)
SINGLE LINE SCAN(R)
SINGLE LINE SCAN(G)
SINGLE LINE SCAN(B)
MONITOR POSITION UPPER LEFT
AUTO ADJUST
BLACK LEVEL ADJUST
Adjust the black level of luminance (Y) to 0%.
ON
WHITE LEVEL ADJUST
Adjust the white level of luminance (Y) to
100%.
ON
RGB ADJUST (BLACK)
Adjust the black level of colours (R/G/B) to 0%.
OFF
RGB ADJUST (WHITE)
Adjust the white level of colours (R/G/B) to
100%.
OFF
SPLIT ADJUST