Panasonic PT-AE3000E - Manual (Page 52)

Appendix
Technical Information
52 -
E
NGLISH
J Communication settings
J Control commands
Signal level RS-232C Character length 8 bits
Sync. method Asynchronous Stop bit 1 bit
Baud rate 9 600 bps X parameter None
Parity None S parameter None
Command Control contents Remarks
PON POWER ON
In standby mode, all commands other than the PON command are ignored.
The PON command is ignored during lamp ON control.
POF POWER OFF
If a PON command is received while the cooling fan is operating after the lamp has switched
off, the lamp is not turned back on again straight away in order to protect the lamp.
IIS INPUT
Parameter:
CP1 = COMPONENT1 IN
SVD = S-VIDEO IN
HD1 = HDMI1 IN
HD3 = HDMI3 IN
CP2 = COMPONENT2 IN
VID = VIDEO IN
HD2 = HDMI2 IN
RG1 = COMPUTER IN
OMN MAIN Displaying the main menu.
OEN ENTER Activating the selected items in the menu mode.
OBK RETURN Returning to the previous menu or escaping from the menu mode.
OCU/OCD/
OCL/OCR
Navigation buttons
OCU = F button
OCD = G button OCL = I button
OCR = H button
OLE LENS Activating the LENS CONTROL menu.
OST DEFAULT Resetting to the factory default setting. (page 28)
OFZ FREEZE
Freezing the projected screen.
Parameter:
0 = OFF
1 = ON
FCI FUNCTION BUTTON Activates the function that is assigned to the FUNCTION button of the remote control.
OOT SLEEP
Setting the duration of time to turn off the power automatically. (See “SLEEP” on page 44.)
0 = OFF
1 = 60min. 2 = 90min. 3 = 120min. 4 = 150min.
5 = 180min. 6 = 210min. 7 = 240min.
OSH BLANK
Turning off the projection temporarily.
Send the command to switch between ON and OFF.
Do not send the command consecutively.
OVM PICTURE Activating the PICTURE menu. Send the command to switch menu items. (page 23)
OWM WAVEFORM
Activating the WAVEFORM.
Parameter:
0 = OFF
1 = FULL SCAN (Y)
2 = FULL SCAN (R)
3 = FULL SCAN (G)
4 = FULL SCAN (B) (page 24)
5 = SINGLE LINE SCAN (Y)
6 = SINGLE LINE SCAN (R)
7 = SINGLE LINE SCAN (G)
8 = SINGLE LINE SCAN (B)
VS1 ASPECT Switching the aspect ratio. (page 24)
VPM PICTURE MODE
Switching the PICTURE MODE. (page 23)
Parameter:
NOR = NORMAL DYN = DYNAMIC CL1 = COLOUR1 CL2 = COLOUR2
CN1 = CINEMA1 CN2 = CINEMA2 CN3 = CINEMA3