Panasonic FW100NTU - Manual (Page 32)

E
NGLISH - 32
Settings
POSITION menu
If the projector is aligned non-perpendicularly to the
screen, or if the projection screen has an angled surface,
you can correct keystone.
You can move the projected image for fine adjustment.
Press I H to move horizontally and F G vertically.
(Available with VIDEO/S-VIDEO/COMPUTER/
COMPONENT signals only)
If you have interference patterns of the projected image,
which is sometimes referred to as moire or noise, you
can minimize it by pressing I H to adjust the clock
frequency. (Available with signals from COMPUTER
only)
If you require further adjustment for the same reason as
the DOT CLOCK adjustment, you can fine adjust the
timing of the clock. Press I H to adjust. (Available with
signals from COMPUTER/COMPONENT only)
You can switch the aspect ratio manually when needed.
Press I H to cycle through the options.
J Aspect ratio options
Q AUTO
Signals which contains an identifying signal will be
detected and automatically project the image in
proper ratio.
Q 4:3
When a 4:3 or 5:4 signal is detected, the image will
be projected without any change, and other signals
will be adjusted to 4:3 with preserving original ratio.
Q 16:9
When a 16:10, 16:9 or 15:9 signal is detected, the
image will be projected without any change, and
other signals will be adjusted to 16:9.
KEYSTONE
Image Operation
NOTE:
• You can correct the distortion ± 30 degrees from the
plane. For a better quality image, installing the projector
with a minimum of distortion is recommended.
• Some distortion may be retained for lens shift
adjustment.
• The distortion of the Main menu screen is not
correctable.
• The result of the keystone correction will affect the
aspect ratio and the size of the image.
POSITION
DOT CLOCK
Remote control Control panel
See “Navigating through the MENU” on page 27.
See “Main menu and Sub-menu” on page 28.
POSITION H
V
NOTE:
• If the projecting signal’s dot clock frequency is higher
than 108 MHz, the adjustment may not make a
difference.
• DOT CLOCK needs to be adjusted before adjusting the
CLOCK PHASE.
CLOCK PHASE
NOTE:
• If the projecting signal’s dot clock frequency is higher
than 108 MHz, the adjustment may not make a
difference.
ASPECT