Panasonic FW100NTU - Manual (Page 35)

OPTION menu
E
NGLISH - 35
Settings
You can check how long the lamp has been used.
You can set the off timer to switch off the POWER of the
projector after a certain period of time automatically
when no signal is detected. Press I H to select the
required period from 15 to 60 minutes at intervals of
5 minutes.
You can switch the projector start up status for when the
Power cord is connected while the MAIN POWER is on,
or for when the MAIN POWER is switched on while the
Power cord is connected. Press I H to select the
required option.
OFF The projector will start from the
standby mode or the projecting
mode.
ON The projector will start from the
projecting mode.
You can turn off the function of the control panel buttons
on the projector body. Press I H to select the required
option.
INVALID Invalidate the control panel buttons
Confirmation screen will be
displayed.
VALID Validate the control panel buttons
You can turn off the AUTO SETUP function for when the
COMPUTER signal is detected.
AUTO When the projector detect a
COMPUTER signal, adjust the
projected image position
automatically for SIGNAL SEARCH,
DOT CLOCK and CLOCK PHASE.
BUTTON Only when the AUTO SETUP button
is pressed, the projected image
position will be adjusted for DOT
CLOCK and CLOCK PHASE. See
“Remote control” on page 11.
You can turn off the auto signal detecting system.
ON Detect the input signal from the
terminals and project the image.
OFF Deactive
When installing the projector, select the projection
method according to the projector position. Press I H
to cycle through the options. See “Projection method” on
page 15.
Select the required screen format by pressing I H.
16:10 When project on a 16:10 or 4:3
screen.
16:9 When project on a 16:9 screen.
LAMP RUNTIME
NOTE:
• LAMP RUNTIME is a relevant matter for lamp
replacement timing. See “Replacing the Lamp unit” on
page 41.
• When the lamp unit is replaced with the new one
(ET-LAF100), the setting will be reset to “0”.
POWER OFF TIMER
DIRECT POWER ON
NOTE:
• When the projector is started from the projecting mode,
pressing the POWER button procedure is skippable.
CONTROL PANEL
DISABLE
15 MIN.
20 MIN.
25 MIN.
30 MIN.
35 MIN.
60 MIN.
55 MIN.
50 MIN.
45 MIN.
40 MIN.
AUTO SETUP
NOTE:
• Usually the recommended setting is AUTO.
SIGNAL SEARCH
NOTE:
• SIGNAL SEARCH is not available when any input
signal is projecting.
• Usually the recommended setting is ON.
INSTALLATION
FRONT/DESK
Setting on a desk/floor and
projecting from front
FRONT/CEILING
Mounting in the ceiling and
projecting from front
REAR/DESK
Setting on a desk/floor and
projecting from rear
REAR/CEILING
Mounting in the ceiling and
projecting from rear
SCREEN FORMAT