PowerTec Regenerative Brushless DC Motor Control 1000AR - Manual (Page 31)

Page
30
Model 1000AR Installation and Operation Manual
6/4/2001 © copyright 1997 by Powertec
Output Terminals
Warning:
Do Not Connect
Input Power Leads
to Output Terminals
Power Input
L1 L2 L3
Input
fuses
Model 1000AR Standard Connections
NOTICE:
ANY POWER EQUIPMENT SWITCHING HIGH VOLTAGES AT HIGH FREQUENCIES EMITS RADIO
FREQUENCY INTERFERENCE ( RFI ) AND ELECTROMAGNETIC INTERFERENCE ( EMI ). THE
MOTOR LEADS MUST BE RUN IN METALLIC CONDUIT TO PREVENT INTERFERENCE WITH
OTHER EQUIPMENT. THIS CONDUIT MUST BE ALL IN ONE PIECE, IF POSSIBLE, AND THIS
CONDUIT MUST BE SOLIDLY GROUNDED. ONLY THE MOTOR LEADS AND THE GROUND WIRE
FROM THE CONTROL TO THE MOTOR SHOULD BE IN THIS CONDUIT.