Panasonic CF-R1 - Manual (Page 30)

30
External Display
For more detailed information, refer to the operation manual of the external
display.
NOTE
External Display Port
VGA Conversion Cable
6
Select your external display
Windows 2000
Set your external display for [Monitor] in [Start] - [Settings] - [Control Panel] -
[Display] - [Settings] - [Advanced].
When a monitor that does not conform to the Plug & Play standards is connected,
select [Monitor] - [Properties] - [Driver] - [Update Driver] and make the monitor
settings.
Windows XP
Set your external display for [Monitor] in [start] - [Control Panel] - [Appearance
and Themes] - [Display] - [Settings] - [Advanced].
When a monitor that does not conform to the Plug & Play standards is connected,
select [Monitor] - [Properties] - [Driver] - [Update Driver] and make the monitor
settings.
Use the included VGA conversion cable to connect an external display.
5
Turn on the external display, then turn on your computer
4
Connect the external display to the VGA conversion cable
2
Attach the core ( “First-time Operation”)
1
Power off your computer ( “Starting Up/Shutting Down”)
Do not shut down using the standby or hibernation function.
The following procedure can be used to switch the display destination after
Windows starts.
Fn + F3
Windows 2000
Select the display destination in [Start] - [Settings] - [Control Panel] - [Dis-
play] - [Settings] - [Advanced] - [Lynx3DM+].
Windows XP
Select the display destination in [start] - [Control Panel] - [Appearance and
Themes] - [Display] - [Settings] - [Advanced] - [Lynx3DM+].
The display destination when Windows is not running (e.g., Setup Utility) is
set under [Display] on the [Main] menu of the Setup Utility. (
page 37 )
The display destination after resuming from hibernation status or when the
computer restarts may not be the same as before entering hibernation
status or before restarting the computer.
When switching the display destination after Windows starts, do not press
any keys or slide the power switch until the display is completely switched.
NOTE
Attach with the mark fac-
ing upward.
To remove: Remove while
pressing on the latch on the
bottom.
3
Connect the VGA conversion cable to the external display port
on your computer