Panasonic CF-R1 - Manual (Page 41)

41
Setup Utility
Save Values & Exit
Exit Without Saving Changes
Get Default Values*
2
Load Previous Values
Save Current Values
Refresh Battery
Exit the Setup Utility and save your changes to CMOS.
Exit the Setup Utility without saving your changes to CMOS.
Set the default settings.
Load previous values from CMOS for all Setup items.
Save your changes to CMOS.
Refreshing the Battery (
page 18 )
Exit Menu
Save Values & Exit
Exit Without Saving Changes
Get Default Values
Load Previous Values
Save Current Values
Refresh Battery
* 2 This item may not be displayed when starting up the Setup Utility with the User Password.
Parameters
Boot Menu
Floppy Disk* 1
Hard Disk
USB CD Drive*
1
LAN
The default order is as follows:
[Floppy Disk] [Hard Disk] [USB CD Drive] [LAN].
To move a device up by one in the order, select the device with and ,and then press
F6 .
To move a device down by one in the order, select the device with and ,and then press
F5 .
Boot First Menu
The device for starting up the Operating System can also be selected during computer
start-up.
After the computer is turned on, the device selection display will appear when ESC is
pressed while “Press ESC to enter Boot First Menu” is shown.
When the setting of the [Boot] menu is changed, the selection screen display will also
change.
The [Boot First Menu] is displayed only when [Display Boot Menu] in [Security] menu is
set to [Enable].
NOTE
* 1 This is displayed even if a floppy disk drive or CD drive
is not connected.
The following drive can be used for startup (recom-
mended).
Panasonic USB floppy disk drive