Panasonic CF-T2 Series - Manual (Page 79)

79
Setup Utility
The Setup Utility is a utility for setting the computer's operating environment (password
settings, startup drive selection, etc.). The following six menu items are available.
[Information], [Main], [Advanced], [Security], [Boot], [Exit]
1
Turn on or restart the computer.
2
Press F2 while [Panasonic] boot screen is displayed soon after the
computer begins the startup procedure.
If [Enter Password] is displayed, enter your password.
When the Setup Utility is started with Supervisor Password
z You can register all items of the Setup Utility.
When the Setup Utility is started with User Password
z You can not register [Advanced] and [Boot] menu.
z On [Security] menu:
• [Clear registered SD card], [Set Supervisor Password] and [Hard Disk
Lock] will not be displayed.
• [Password on boot], [SD Startup], [SD Setting Method], [Setup Utility
Prompt], [Boot First Menu] and [User Password Protection] will be
displayed, but cannot be set.
• The User Password can be changed only when [User Password
Protection] has been set to [No Protection]. The User Password cannot be
deleted.
z [Get Default Values] will not be displayed on [Exit] menu.
z
F9 does not work.
NOTE
z When [Password on boot] in the Setup Utility is set to [Disable], the password is not
necessary when the computer is started up, but the password becomes necessary
when the Setup Utility is started up. This alternative makes it possible to prevent the
contents of the Setup Utility from being changed.
z If you fail to press F2 at the right moment, the Setup Utility will not start up. In this
case, power off the computer and try again.
z To close the Setup Utility, press Esc, select the exiting method in [Exit] menu, then
press Enter.
Running the Setup Utility