Panasonic DMR-E500H - Manual (Page 34)

34
RQT7394
Pla
y
ing ba
c
k
Playing still pictures
Only insert or remove the SD/PC card after turning the unit off.
When the card indicator (“SD” or “PC”) on the unit’s display is
flashing, the card is being read from or written to. Do not turn off the
unit or remove the card. Such action may result in malfunction or
loss of the card’s contents.
∫ SD card slot
≥ You can use SD Memory Cards with capacities from 8 MB to 1 GB
( ➡ page 21).
∫ PC card slot
Regarding still pictures (JPEG, TIFF)
≥ Compatible formats:DCF § compliant (Content recorded on a
digital camera etc.)
§ Design rule for Camera File system: unified standard
established by Japan Electronics and Information Technology
Industries Association (JEITA).
≥ File format: JPEG, TIFF (non-compressed RGB chunky format)
≥ Number of pixels: 34 k 34 to 6144 k 4096
(Sub sampling is 4:2:2 or 4:2:0)
≥ This unit can handle a maximum of 3000 files and 300 folders
(including higher folders).
≥ Operation may take time to complete when playing TIFF format
still pictures, or when there are many files and/or folders, some
files may not display or be playable.
≥ MOTION JPEG is not supported.
POWER
VOLUME CH INPUT SELECT
DVD POWER
TV
TV/VIDEO
1
HDD SD/PC DVD
2 3
4 5 6
7 8
0
9
CM SKIP
AUDIO
PAGE
CH
CANCEL VCR Plus+
SKIP
STOP PAUSE PLAY/x1.3
SLOW/SEARCH
FUNCTIONS
ENTER
DIRECT NAVIGATOR
TOP MENU
RETURN SUB MENU
CHAPTER
SETUP
Info
PROG/CHECK TV GUIDE
REC MODE ERASE REC
STATUS
TIME SLIP DISPLAY
DUBBING
HDD DVD
HDD DVD SD PC TIME SLIP DRIVE SELECT /x1.3
OPEN/CLOSE
PC CARD
EJECT
SD CARD
POWER
3 4 2 1
ENTER
SUB MENU
ERASE
DRIVE SELECT
HDD, DVD,
SD/PC
STATUS
DIRECT
NAVIGATOR
∫
∫
Numbered
buttons
HDD, DVD, SD, PC indicator SD card slot
PC card slot Inserting/Removing the SD/PC card
Inserting the card
Removing the card
Inserting the card
There are cards requiring adaptors (
➡ page 21).
Removing the card
≥ If using the adaptor, remove the adaptor and card together.
POWER
Insert label up with cut-off corner at the right.
Insert straight-in until it fits
into space.
1
2
POWER
Press on the center of the card.
Draw straight out.
POWER 2
1
Hold the edge of the card and insert until it
fits into place.
≥ If using the adaptor, do not press directly
on the card.
Terminal connections facing into the unit
2 align to match
the mark
The labeled side facing upwards
POWER
1 2
Push
Eject button
comes out
Push again
7394en.book Page 34 Wednesday, March 30, 2005 9:45 AM