Panasonic DMC-LS80 - Manual (Page 38)

-  -
Advanced-Shooting
Making the LCD monitor easier to
see (LCD mode)
Press and hold [Q.MENU] until
quick setting screen is displayed.
Q.MENU
Select indication at the right end
(initial setting: [OFF]) using q,
select mode using e/r and press
[MENU/SET].
SELECT EXIT
1�
2�
Mode Uses
AUTO
POWER LCD
Brightness of the LCD monitor
automatically changes
depending on brightness of
the environment.
POWER
LCD
The LCD monitor becomes
brighter and easier to see
even when taking pictures
outdoors.
HIGH
ANGLE
This is useful
when you cannot
get close to the
subject because
there is a person
in the way.
(More difficult to
see when looked
straight on.)
OFF The LCD monitor returns to
the normal brightness.
You can set LCD mode in setup menu.
(P21)
High angle mode is cancelled if you
turn the camera off. (Same occurs in
[POWER SAVE].)
The LCD monitor automatically returns to
normal brightness after 30 seconds when
recording in power LCD mode. Press any
button to make the LCD monitor bright
again.
The brightness of the pictures displayed
on the LCD monitor is adjusted when
power LCD mode or high angle mode
is activated. Therefore, some subjects
may look different on the LCD monitor.
However, this does not affect the
recorded pictures.
If the screen is difficult to see because of
light from the sun etc. shining on it, use
your hand or another object to block the
light.
The number of recordable pictures
decreases when the auto power LCD,
power LCD or high angle mode is used.
•
•
•
•
•
•