Paxar 9474 - Manual (Page 24)

To adjust for wide or narrow supplies:
1. Turn the printhead lever to the left to release the printhead.
2. Pull out the supply width adjustment knob and
◆ turn it to "NARROW" for supplies two inches in width or
smaller
◆ turn it to "WIDE" for supplies greater than two inches in
width.
Be sure the adjustment knob snaps back into
place after you turn it.
3. Turn the printhead lever to the right to lock the printhead.
U s i n g t h e K n i f e G u a r d
The knife guard is a safety cover for the knife and should be in
use at all times except when a stacker is attached.
WARNING
Do not operate the printer without the knife guard or
stacker in place.
Knife
Guard
Loading Supplies 2-13