Pioneer VSX-520 - Manual (Page 15)

Controls and displays 02
15
En
English
Français
Deutsch
Nederlands
Italiano
Español
TEST TONE
Outputs the test tones on each channel.
Use the / buttons to select the channel
and use the / buttons to adjust the
level on each channel. Pressing TEST
TONE again exits the test tone mode.
SB CH
Press to select
ON, AUTO, OFF the
surround back channel.
CH SELECT
Press repeatedly to select a channel, then
use
LEV +/– to adjust the level (page 39).
LEV +/–
Use to adjust the channel levels.
MIDNIGHT
Switches to Midnight or Loudness
listening (page 33).
SPEAKERS
Use to change the speaker system on or
off. When the
SP OFF is selected, no sound
is output from the speakers connected to
this receiver.
DIMMER
Dims or brightens the display. The
brightness can be controlled in four steps.
12  SOURCE
Turns on or off the power of the Pioneer DVD/
DVR units when
BD, DVD, DVR or CD is
selected using the MULTI CONTROL buttons.
13 TV CONTROL buttons
These buttons can control only be used with
Pioneer flat panel TVs.

Use to turn on/off the power of the TV.
INPUT
Use to select the TV input signal.
CH +/–
Use to select channels.
VOL +/–
Use to adjust the volume on your TV.
DTV/TV*
Switches between the DTV and analog TV
input modes for Pioneer flat panel TVs.
14 MASTER VOLUME +/–
Use to set the listening volume.
15 MUTE
Mutes/unmutes the sound.
16 DISP
Switches the display of this unit. The listening
mode, sound volume, Pre Out setting or input
name can be checked by selecting an input
source.
1
17 SHIFT
Press to access the ‘boxed’ commands (above
the buttons) on the remote. These buttons are
marked with an asterisk (
* ) in this section.
Note
1 The Pre Out setting may or may not be displayed, depending on the input source you have selected.
VSX-520_UCSMXCN_En.book 15 ページ ２００９年１２月１５日 火曜日 午後２時３３分