Pioneer VSX-520 - Manual (Page 18)

Connecting your equipment 03
18
En
Connecting the speakers
The receiver will work with just two stereo
speakers (the front speakers in the diagram)
but using at least three speakers is
recommended, and a complete setup is best
for surround sound.
Make sure you connect the speaker on the
right to the right (
R) terminal and the speaker
on the left to the left ( L) terminal. Also make
sure the positive and negative ( +/–) terminals
on the receiver match those on the speakers.
If you’re not using a subwoofer, change the
front speaker setting (see Speaker setting on
page 38) to
LARGE.
Be sure to complete all connections before
connecting this unit to the AC power source.
Bare wire connections
Front speaker terminals:
1 Twist exposed wire strands together.
2 Loosen terminal and insert exposed wire.
3 Tighten terminal.
Center and surround speaker terminals:
1 Twist exposed wire strands together.
2 Push open the tabs and insert exposed
wire.
3 Release the tabs.
1 2 3
10 mm
(
3 / 8 in.)
1 2 3
10 mm
(
3 / 8 in.)
SURR BACK /
FRONT
HEIGHT
L
(Single)
R
L
IN IN
OUT
CD DVR/VCR
MONITOR OUT
P P Y
Class 2 Wiring
DVD IN BD IN
FRONT
SURROUND CENTER
R L
R L
CD-R/TAPE
DVR/VCR CD-R/TAPE
PRE OUT
E
ADAPTER PORT
VIDEO
SPEAKERS A SUBWOOFER
PRE OUT
(OUTPUT 5 V 100 mA MAX)
TV/SAT
IN
DVR/VCR
OUT IN
SW L C R SL SR
Center speaker Surround speakers Front speakers Powered subwoofer
VSX-520_UCSMXCN_En.book 18 ページ ２００９年１２月１５日 火曜日 午後２時３３分