Pantech DM P100 - Manual (Page 8)

11
CH 1
BATTERY USAGE
CHARGING
Power Connection
Plug one end of the AC charger into the bottom of
the phone and the other into a standard outlet. Your
phone's battery must be installed correctly to charge
at maximum capacity.
10
CH 1
BATTERY USAGE
INSTALLATION
Place the battery on the back of the handset and slide
until it locks into place.
REMOVAL
On the back of the handset, push the release latch
down, lift the battery up and remove it from the handset.
NOTE:
IF THE BATTERY IS NOT INSTALLED CORRECTLY, THE PHONE WILL NOT POWER ON
AND/OR THE BATTERY MAY DETACH DURING USE.
NOTE:
• UPON PURCHASE, BATTERIES MUST BE FULLY CHARGED FOR EIGHT HOURS
BEFORE USING THE PHONE.
• WHEN CHARGING POWERED-OFF PHONES, A STATUS MESSAGE WILL APPEAR
ON THE INTERNAL DISPLAY SCREEN. YOUR PHONE WILL NOT OPERATE UNTIL
POWERED ON.
• IN ADDITION TO BEING CORRECTLY CONNECTED TO YOUR PHONE, BATTERIES
WILL CHARGE MORE EFFICIENTLY WITH THE PHONE POWER OFF.
• BATTERY OPERATING TIME WILL GRADUALLY DECREASE WITH USE.
• IF THE BATTERY FAILS TO PERFORM PROPERLY, IT MAY NEED TO BE
REPLACED.