Epson GT-30000 - Manual (Page 36)

2-16 Setting up the Scanner
R4C3820
Rev. C
A5 size SETUP.FM
4/9/01 Pass 0
L Proof Sign-off:
KOW S.Koide C.Fujiwara
J.Miyakoshi
NOC Lee
Connecting the scanner
Use the following steps to connect the scanner to your PC or to
another SCSI device.
Note:
The combination of connectors on the SCSI interface cable you need
varies depending on the maker of your SCSI device and SCSI interface
board.
1. Make sure the scanner, your PC, and all other SCSI devices
are turned off and unplugged from the power source.
c
Caution:
Do not connect the scanner to your PC or other devices while
they are turned on, otherwise damage may occur.
2. Connect one end of the interface cable to a suitable scanner
SCSI connector until the locks on both sides snap in.
Note:
❏ To connect the scanner to a PC or any other SCSI device, the total
length of cable in the daisy chain must not exceed 3 meters;
otherwise the system may not work properly.
❏ Make sure no other interface is used.
❏ Before connecting the scanner to a PC, you need to set the select
switch. See “Setting the select switch” on page 2-15 for details.