Panasonic PANAFAX DF-1100 - Manual (Page 48)

46
Basic Transmission Settings
You can temporarily change the following transmission settings either before or after you place the document
on the ADF or Platen Glass.
•
Contrast
•
Resolution
•
Stamp
•
Communication Journal
After your document has been sent, your machine will automatically return to the preset settings.
Contrast
Your machine is preset to Normal contrast. If you wish to send a document with lighter contrast, change the
setting to Lighter or Lightest. If you wish to send a document with darker contrast, change the setting to
Darker or Darkest.
Press CONTRAST to:
CONTRAST
= Normal
A "
CONTRAST
= Darker
A "
CONTRAST
= Darkest
A "
CONTRAST
= Normal
A "
CONTRAST
= Lighter
A "
CONTRAST
= Lightest
A "
CONTRAST CONTRAST CONTRAST CONTRAST CONTRAST CONTRAST
OR
To change the preset Contrast position, change the setting of Fax Parameter No. 01 (see page 38).
Resolution
Your machine is preset to Standard resolution, which is suitable for most documents.
Use Fine or Super Fine for detailed documents or Photo for photographs or illustrations with gray tones.
Press RESOLUTION to:
RESOLUTION = Standard
RESOLUTION RESOLUTION
RESOLUTION = Fine
FINE S-FINE PHOTO FINE S-FINE PHOTO
RESOLUTION
RESOLUTION = Super Fine
FINE S-FINE PHOTO
RESOLUTION
RESOLUTION = Photo
FINE S-FINE PHOTO
To change the preset Resolution position, change the setting of Fax Parameter No. 02 (see page 38).
Verification Stamp
STAMP = Off STAMP = On
STAMP STAMP
The Verification Stamp helps you to confirm successful
transmissions by stamping the bottom of each
successfully transmitted page with a small
mark.
Press STAMP to:
1. When you store a document in memory, the Verification Stamp will stamp on the document if it is
successfully stored in memory. In this case the Verification Stamp is not a confirmation that the document
was successfully transmitted. If you wish to disable the use of the Verification Stamp when storing a
document in memory, change the setting of Fax Parameter No. 28 (see page 39).
2. To change the preset Verification Stamp position, change the setting of Fax Parameter No. 04 (see page
38).
04002000001
04002030004
04002020006
04002050006
Note:
04002070001
04002020002
04002050002
Note:
04002070002
04002020004
04002050004
Note:
04002070007
04002070005