Paxar 4 - Manual (Page 23)

4. Feed the labels over the peel bar and through the lower
opening in the supply guide.
5. Close the printer and turn the printer on.
6. Wait until the LED flashes one time (about five seconds)
and then press the trigger. The printer advances the first
label to the correct position for printing. When you print,
labels peel automatically through the top opening in the
supply guide and the backing paper exits out the bottom
opening.
n
The LED slowly alternates flashing amber and green to
indicate the printer is out of labels. When this happens, load a
new roll of labels and press the trigger to clear the error.
Upper
Opening
Lower
Opening
Label
Guide
9490 Operator’s Handbook
2-10
TC9490OH Rev. C 3/97