Paxar 4 - Manual (Page 42)

Chapter 6. Using the Boot
The Monarch® Renegade® 4 printer’s boot protects it if you
accidentally drop it, hit it against something, or jar it in some
other manner. Following is an illustration of the boot on the
printer.
Putting the Boot on the Printer –––––––––––––––––––––––––––––––
To put the boot on the printer:
1. Industrial Version Only. Remove the cable from the side
of the printer. Save the cable’s screws for when you want
to use the printer without the boot.
2. Unscrew the screw assemblies at the top of the printer
(either shoulder strap is optional), and take them off.
Save them for when you want to use the printer without
the boot.
3. Pull on the boot and fit it around the printer.
6-1
TC9490OH Rev. C 3/97