Paxar 4 - Manual (Page 46)

Chapter 7. Using the Cable Cover
You use the cable cover with the industrial version of the
Monarch® Renegade® 4 printer. The cover holds the cable in
place. You can use the cable cover with or without the
printer’s boot.
Attaching the Cable Cover––––––––––––––––––––––––––––––––––––
To attach the cable cover:
1. Remove the cable from the printer.
2. Boot Only. Insert the spacers into the holes on the lower
right side of the printer. (You can have the boot on or off
the printer.)
7-1
TC9490OH Rev. C 3/97