Panasonic PT-D995U - Manual (Page 17)

Installing the Projector
Precautions for Installation
Do not install the projector in places where :
There is much water, humidity or dust.
The projector may be subjected to oil smoke or cigarette smoke.
The surface is soft, such as a carpet or cushion.
The projector may be subjected to direct sunlight.
Temperature is high or humidity is low.
Allowable operation temperature range: + 5°C to + 35°C (41°F to 95°F)
Allowable relative humidity range:
20% to 80% (no condensation)
Allowable storage temperature range: -10°C to +60°C (14°F to 140°F)
When installing the projector, observe the followings:
Do not use the projector placed on its side.
Avoid using the projector placed on its side. This could cause a malfunction.
Use the projector within the installed angle.
Avoid using the projector inclined ±30° or more right-to-left or left-to-right. This could cause color variation or harm the lamp
life.
Do not block the exhaust vents.
Do not use a cover which encloses the projector air-tight or blocks the exhaust vents. Allow sufficient space around the
projector. When the projector is enclosed in a space of the following dimensions, use an air conditioner so the temperature
inside becomes equal to the outside temperature.
Allowable minimum space required
20cm (7 - 7/8”)
20cm (7 - 7/8”)
50cm (19 - 3/4”)
20cm (7 - 7/8”)
20cm (7 - 7/8”)
17