Polaris ATP 500 4x4 - Manual (Page 109)

106
MAINTENANCE AND LUBRICATION
Lights
High Beam Adjustment
The headlight beam can be adjusted to any position desired by turning
the adjusting knob on the bottom right side of the headlight pod.
1. Position the vehicle on a level surface with the headlight
approximately 25 ft. (7.6 m.) from a wall.
2. Remove the two screws on the lower front corners of the headlight
pod.
3. Using a small flat-blade screwdriver, push in on the lock tab
through the two small openings at the front of the headlight pod.
4. Lift the pod slightly while depressing the tabs.
5. Remove the screw in the back of the headlight pod.
6. Measure the distance from the floor to the center of the headlight
and make a mark on the wall at the same height.
7. Start the engine and turn the headlight switch to high beam.
8. Observe the headlight aim on the wall. The most intense part of
the headlight beam should be aimed two inches (5.1 cm) below the
mark placed on the wall. NOTE: Include rider weight on the seat
when measuring.
9. Adjust the beam to the desired position by turning the adjustment
knob either clockwise or counterclockwise.
10. Reinstall the pod.
Snap pins
into tabs
Position
knob in
slot and
secure in
locking
tabs
Slip o-ring
over pin
Adjustment
Knob Stop
Route plug
over handlebar