Polaris ATP 500 4x4 - Manual (Page 40)

37
FEATURES AND CONTROLS
Electrical Switches
While operating in reverse, activating the override switch with the
throttle open can cause loss of control, resulting in severe injury
or death. Do not activate the override switch while the throttle is
open.
WARNING
Speedo Mode/Override Switch (1) (Reverse Speed Limiter) - This
switch, if pressed while in any gear but reverse, will change the display
mode of the speedometer (if equipped). To gain additional power
while operating in reverse, depress the override switch before opening
the throttle. NOTE: The override switch also allows activation of
Demand 4 Drive (All Wheel Drive) in reverse, if the Demand 4 Drive
switch is on.
Main Switch (2) - To start the engine, slide the stop switch to the
center RUN position and turn the main key switch clockwise past the
ON position. Release the key when the engine starts. NOTE: Turn off
the main switch to end all electrical power to the vehicle, including the
cooling fan and lights.
1
2
3
Leaving the keys in the ignition can lead to unauthorized use of
the vehicle resulting in serious injury or death. Always remove
the ignition key when the vehicle is not in use.
WARNING
A large key fob or key ring may contact the gas tank cap, causing
an interruption to the electrical system and an unexpected engine
shut-down during operation. This could result in serious injury or
death. Do not attach a large key fob or key ring to the main switch.
WARNING