Polaris ATP 500 4x4 - Manual (Page 95)

92
MAINTENANCE AND LUBRICATION
Engine Cooling System
Radiator Coolant Level (ATP 500)
NOTE: This procedure is required
only if the cooling system has been
drained for maintenance and/or repair.
However, if the recovery bottle has
run dry, the level in the radiator
should be inspected and coolant
added if necessary.
1. Using the tool provided, remove
the four screws securing the front
compartment (1). Remove the
front cover (2) by placing your
fingers under the front of the cover
and pulling upward.
2. Remove the pressure cap.
3. Using a funnel, slowly add coolant as necessary through the
radiator filler neck.
4. Replace the pressure cap and secure the front cover.
NOTE: Use of a non-standard pressure cap will not allow the
recovery system to function properly. Contact your dealer for the
correct replacement part.
WARNING
Escaping steam can cause severe burns. Never remove the
pressure cap while the engine is warm or hot. Always allow the
engine to cool before removing the pressure cap.
2
1