Paxar 9856 - Manual (Page 30)

4-4 Communication Values
F l o w C o n t r o l
To change the setting, from the Main Menu, select Setup, Port Settings,
then User Comm. Then, follow these steps.
1. Press L or R until you see
2. Press E. You will see the current setting, for example:
The XON character is 17; XOFF is 19. Set flow control to DTR for PC
computers (unless you have XON/XOFF software).
3. Press L or R to display the flow control you need, press E. Press
U three times to exit to the Main menu.
R e s e t t o D e f a u l t V a l u e s
To change the setting, from the Main Menu, select Setup, Port Settings,
then User Comm. Then, follow these steps.
1. Press R until you see
2. Press E. You will see
3. Press L or R to make your selection, press E. Press U three times
to exit to the Main Menu.
USER COMM
l Flow Control r
FLOW CONTROL
l DTR r
USER COMM
l Reset
Are you sure?
No
r