Panasonic KX-FM106 - Manual (Page 76)

76
Receiving Faxes
Extension telephone !
If you connect an extension telephone to your unit or to the same line, you can receive fax documents using
the extension telephone.
You do not have to press
(START/SET/COPY) on the unit.
Important:
≥ Use a touch tone telephone as the extension telephone and enter the fax activation code firmly.
1 When the extension telephone rings, lift the
handset of the extension telephone.
2 When:
—document reception is required,
—a fax calling tone (slow beep) is heard, or
—no sound is heard,
press
($) (9) (pre-selected fax activation code)
firmly.
3 Hang up the handset.
≥ The unit will start reception.
Fax activation code !
The fax activation code is required in the following cases;
—to receive faxes using an extension telephone (see above).
—to receive a voice message and fax document in the same call (p. 69).
Important:
≥ This code should be different from the remote activation ID (p. 69) and the auto disconnection code (p. 79).
1 Press (MENU) .
Display:
2 Press (#) , then (4) (1) .
3 Press (START/SET/COPY) .
4 Press or to select “ON”.
● If this feature is not required, select “OFF”.
5 Press (START/SET/COPY) .
≥ The display will show the pre-selected code.
6 Enter the new code.
● This code can be from 2 to 4 digits in length using
0 – 9, and
£
.
7 Press (START/SET/COPY) .
8 Press (MENU) .
SETUP ITEM [ ]
CODE= ¢ 9
MODE=ON ▼▲
FAX ACTIVATION
1.SYSTEM SET UP
Note:
≥ You can change the fax activation code (see
below).
Note:
≥ If you subscribe to any special telephone
company services which require a code, all or
part of the fax activation code must be
different from the service access code.
≥ The fax activation code should not be set to
“0000”.
To the EXT jack or
the same line
Extension telephone
1 2 3
4 5 6
7 8 9
0
/
START/SET/COPY
MENU