Paxar Monarch 9433 - Manual (Page 41)

Setting Up the Printer 3-11
Setting the Demand Sensor
Use this option to enable or disable the on-demand sensor.
When you select:
♦ disable, printing is activated by pressing F.
♦ enable, printing is automatic when the previous printing is removed.
When using on-demand with the tear edge and peel mode, you need to
set up the printer:
♦ For tear edge, use only non-indexed supplies (continuous), supplies
without separations or black marks, and linerless supplies.
♦ For peel mode (separates the label from the liner).
To set the on-demand sensor:
1. From the Printer menu, select Demand Sensor.
Disable
Enable
↵ d
2. Make your selection: Disable or Enable. For example:
Sensor Enabled
↵
3. Press A under ↵ to save the setting.
Setup Supply...
Then hit Enter
↵
4. Setup your printer for the tear edge or peeling labels.