Paxar Monarch 9433 - Manual (Page 45)

Setting Up the Printer 3-15
Selecting the Die Cut Sensor
1. From the Printer menu, select Stock Sensor, Die Cut.
Die Cut Sensor
Selected
↵
2. Press A under ↵ to continue.
Insert liner...
Then hit Enter
↵ ±
3. Load the supply by separating one or two labels from the liner and
placing the liner across the black mark sensor and through the exit
chute.
4. Close the supply door.
5. Press A under ↵ to continue. You see a message that the printer is
calibrating the supply.
SUCCESSFUL
↵ X
The printer does not feed labels while calibrating. The printer
records the sensor value read from the liner.
Exit chute