Precor Elliptical Fitness Crosstrainer EFX - Manual (Page 87)

Product Owner's Manual: Club Features 25
Treadmill: Accessing Performance
Programs
The performance-based Gerkin Fitness Test on the treadmill can
be hidden from the user’s view and, consequently, be unavailable
during an exercise session.
If you keep the default factory setting, the Track program appears
when the PERFORMANCE key is pressed.
If you wish to change this setting, perform the following steps:
1.
Press OK to review the current
H I D D E N P R O G R A M S
selection. Use the navigational arrow keys to alternate between
the two selections.
Setting Description
S H O W
P R O G R A M S Causes the Fitness Test to appear and replace
the Track program when a user presses the
PERFORMANCE key.
H I D E
P R O G R A M S Hides the Fitness Test and makes it inaccessible
to the user. The Track Program appears when a
user presses the PERFORMANCE key.
2.
When you are ready, press OK to accept the displayed setting
and move to the next program. For other options, refer to the
table in Changing the Product Settings.
Treadmill: Changing Remote Control
Access
Important: To affect this setting, the treadmill must be connected
to a computer and you will need to be familiar with CSAFE
commands.
When you enable this program, you can set a user’s speed and
incline through a computer software program which interfaces with
the CSAFE port on the treadmill.
The default factory setting is set to D I S A B L E D . To change this
setting, perform the following steps:
1.
At the
R E M O T E S P E E D C O N T R O L prompt, press OK. Use
the navigational arrow keys to alternate between the two
selections.
Setting Description
E N A B L E D Lets you set the speed and incline for individual
users and their selected program using CSAFE
commands through a computer connection.
D I S A B L E D Disconnects remote access so you cannot use the
remote capabilities of a CSAFE connection. You
would also use this setting when the treadmill is not
connected to a computer.
2.
When you are ready, press OK to accept the displayed setting
and move to the next program. For other options, refer to the
table in Changing the Product Settings.