Polycom SpectraLink 8030 - Manual (Page 103)

Diagnostic Tools
PN: 1725-36038-001_E.doc 103
• Weak – signal strength too weak
• Rate – one or more basic rates not supported
• Full – AP can not handle bandwidth requirements
• AthT – authentication timeout
• AscT – association timeout
• AthF – authentication failure
• AscF – association failure
• SecT – security handshake timeout
• SecF – security handshake failure
• Cnfg – AP not configured correctly for security, QoS mode or
infrastructure network
• CCX – AP is not CCX complaint.
• CCKM – AP does not support CCKM.
• WMM – AP does not meet the WMM requirements. Probable
reason could be that the access categories AC_VO and AC_VI,
used for voice and control traffic respectively, might not be
marked as mandatory or WMM-PS might not be enabled.
Screen 4
• Association count since power up (AssocCount)
• Re-association count since power up (ReAssocCount)
• Association failures since power up (AssocFailure)
• Re-association failures since power up (ReAssocFail)
A s s o c C o u n t n n n n n
R e A s s o c C o u n t n n n n n
A s s o c F a i l u r e n n n n n
R e A s s o c F a i l n n n n n
Screen 5
• WEP only security error count since power up (Sec-ErrCount)
• MAC sequence number of frame with last security error
(LstSecErrSeq)
• (Re)Association failures due to QoS (QoSFailCnt). Usually
attributed to insufficient available bandwidth on an AP.