Polycom SpectraLink 8030 - Manual (Page 62)

SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SIP
62 PN: 1725-36038-001_E.doc
Parameter Value Description Notes
PROXYn_
KEEPALIVE_SECS
Not used in
8020/8030 0 or 10 to 3600
seconds
*default = 0 Specifies that the handset
should send keepalives to
the PROXYn server. n = 1, 2, 3
The keepalive interval
defaults to ZERO which
disables the feature.
When specified, the
interval can be set to zero
or to 10 to 3600 seconds.
If a keepalive fails to get a
response within the SIP 32
second timeout, then
keepalives are terminated
until the next successful
registration to the proxy.
See example file.
PROXYn_
KEYPRESS_2833 *enable
disable
*default (in example
file) Controls generation of in-
stream RFC2833
formatted key press
events. Match what is
required by your PBX. See
RFC2833. See config file
example for more
information. n = 1, 2, 3
Must be disabled for OAI.
PROXYn_
KEYPRESS_INFO enable
disable Controls generation of SIP
INFO requests to the SIP
server for keypress
events. Normally enabled. n = 1, 2, 3
Must be enabled for OAI.
PROXYn_HOLD_IP0 enable
disable
Controls setting of the
media stream IP
destination address to 0
(zero) when a call is put
on hold. See config file
example for more
information. n = 1, 2, 3
Use for compatibility with
older SIP servers that may
not recognize newer
stream attribute
parameters for HOLD
status.
PROXYn_PRACK enable
disable Enables reliable
provisional responses to
INVITE requests n = 1, 2, 3
PROXYn _
MAIL_SUBSCR [email protected]
or Contact to whom the
handset should subscribe
for mail notification. See
config file example for
more information. n = 1, 2, 3
name = mail server contact
name.
xxx.xxx.xxx.xxx = IP4
address.
sip:name@domain Domain where the mail
resides
3 .
3 For mail notifications, in general you will need to define only one contact parameter for each proxy. If the proxy