Panasonic WV-CLR920A - Manual (Page 34)

5. Electronic Sensitivity Enhancement
(SENS UP)
There are two modes for SENS UP.
AUTO: If you select X32 AUTO, for example, the
sensitivity is raised automatically to X32 max.
When AUTO is selected, AGC is automatically
set to ON.
FIX: If you select X64 FIX, for example, the sensitiv-
ity is raised to just X64.
Move the cursor to SENS UP and select the parameter
for electronic sensitivity enhancement.
The preset values for SENS UP (electronic sensitivity
enhancement) change by pressing
L or M as fol-
lows:
-34-
ON (DNR-M): Applies AGC with middle-level DNR.
ON (DNR-L): Applies AGC with low-level DNR.
Notes:
• The higher the DNR level becomes, the more after
images and the less noise you will see.
• Selecting DNR-L is recommended when the picture
contains moving objects.
• When using a system controller, the parameters
(DNR-H/M/L) will not appear on its setup menu.
2. Press
I (set) to open the AGC MAX (maximum
level) menu.
3. Move the "I" cursor with L or M to adjust the
AGC level.
4. Move the cursor to RET and press I to return to
the CAM SET UP menu. When closing the menu,
move the cursor to END and press
I.
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
RET
↵
↵
↵
↵
** AGC MAX **
LEVEL ....I....
- +
RET END
X2 AUTO OFF X4 AUTO X6 AUTO X10 AUTO
X32 FIX X64 FIX X16 FIX X10 FIX X6 FIX X4 FIX X2 FIX OFF
X16 AUTO X32 AUTO