Panasonic WV-CLR920A - Manual (Page 43)

-43-
The camera will deactivate the detector for a few
minutes after the power of the camera is turned on
or the BW setting in the Special Menu is set to
other than OFF.
9. Move the cursor to DWELL TIME, and select a time
with
L or M.
When the time specified here elapses after motion
detection, the camera will notify the connected
device of the alarm activation. The default setting is
2S.
Available Time (second): 2 s, 5 s, 10 s, 30 s
Notes:
• Masking or adjusting the detection level is needed
to prevent malfunction under the following condi-
tions:
• When shooting an object under flickering fluo-
rescent light or shooting in ELC.
• When leaves or curtains etc. are swayed by the
wind.
• When the object is lighted by lighting equip-
ment that constantly turns on and off.
• Set MOTION DET to OFF when the camera is
installed in a system other than a Panasonic CCTV.
Otherwise the multiplexed alarm signal may be mis-
understood as a time-code.
• There may be a delay of about 0.2 seconds from
the time of motion detection until the ALARM OUT
terminal becomes active.
9. Lens Drive Signal Selection
(LENS DRIVE)
This item is used to select the type of auto iris lens drive
signal to be supplied to the lens from the auto iris lens
connector.
1. Move the cursor to LENS DRIVE.
2. Select DC or VIDEO depending on the type of lens
installed. The default setting is DC.
DC: Controls the DC-driven type lens.
VIDEO: Controls the video-driven type lens.
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
RET
↵
↵
↵
↵