Panasonic WV-CLR920A - Manual (Page 38)

-38-
The SC FINE adjustment has a range of 90 degrees
of colour shift.
Notes:
• When the “I” cursor reaches the “+” end, it
jumps back to “–”. At the same time, SC
COARSE is incremented by one step to enable
a continuous adjustment. The reverse takes
place when the “I” cursor reaches the “–” end.
• When
L or M is kept pressed for a second
or more, the “I” cursor moves faster.
• For more accurate adjustment, supply both the
original camera video output signal and the
effect output video signal (program output
video signal) of the special effects generator
(SEG) to a vectorscope and compare the chro-
ma phase of both signals.
• To reset SC COARSE and SC FINE to the val-
ues preset at the factory, press L and M
simultaneously.
6-3. VS Gen-lock Mode (EXT(VS))
1. Move the cursor to SYNC and select INT.
2. Connect the coaxial cable for the composite sync
or composite B/W video signal to the gen-lock input
connector.
3. Confirm that INT changed to EXT (VS) on the menu.
Caution: The gen-lock input signal should meet the
CCIR specifications and should not contain jit-
ter, such as a VTR playback signal, as it could
disturb synchronization.
4. After confirming that the cursor is on EXT (VS),
press
I. The phase adjustment menu appears
on the monitor.
5. Supply the video output signal of the camera to be
adjusted and the reference gen-lock input signal to
a dual-trace oscilloscope.
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
RET
↵
↵
↵ ↵
↵
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC EXT(VS)
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
RET
↵
↵
↵
↵
** SYNC **
H PHASE ........I
- +
RET END