Panasonic WV-CLR920A - Manual (Page 35)

mode is automatically set to internal sync pulse,
and the menu is not displayed.)
Rules on synchronization
• The priorities for the sync mode are as follows. A
higher mode will overrule lower ones.
1. Multiplexed Vertical Drive (VD2) (Highest priori-
ty)
2. Line-lock (LL)
3. Colour Composite Video or Blackburst Signal
(VBS)
4. B/W Composite Video or Composite Sync
Signal (VS)
5. Internal Sync (INT) (Lowest priority)
• When the internal sync mode is to be used, select
INT. No gen-lock input signal should be supplied to
the Gen-lock Input Connector on the rear panel.
-35-
Notes:
• While the SENS UP function is active, the increased
sensitivity may cause noise, spots or a whitish phe-
nomenon to appear in the picture. This is a normal
phenomenon.
• X64 FIX does not appear for the SENS UP parame-
ter on the system controller setup menu.
• In case of using the WV-CU204 or WV-CU254
Controller, status does not appear correctly for the
SENS UP parameter on the setup menu.
6. Synchronization Setting (SYNC)
You can select internal sync mode (INT) or line-lock
mode (LL). Additionally, this model accepts the VBS
signal (colour composite video or blackburst signal)
and VS signal (B/W composite video or composite sync
signal). The VD2 signal (multiplexed vertical drive sig-
nal) with the composite video output signal from exter-
nal equipment such as a Matrix Switcher is also accept-
able.
Whenever the VD2 signal is supplied to this camera, the
camera automatically switches to the VD2 sync mode.
1. Move the cursor to the SYNC parameter and select
line-lock (LL) or internal (INT).
2. Press
I.
If LL is selected, the SYNC menu appears. See
page 37. (If INT is selected, the synchronization
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON (DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
RET
↵
↵
↵