Panasonic AJ-D700P - Manual (Page 125)

If trouble is detected immediately after the power is turned on or during operation, the display window (LCD), WARNING lamp,
lamps inside the viewfinder, and warning tones from the speaker and earphone inform the operator of trouble.
Display window (LCD) Lamps
Item
RF
Remain-
Remain-
Warning Warning ing WARN- REC
display battery
ing tape ING
display
status level length
lamp
lamp
display display
Warning
tone
Warning
contents
RF
Lighted
* 1 )
Emitted Flashes Flashes
4 times
Video head
4 times 4 times clogging,
per per per
second recording
second second
*1)
system trouble
SERVO SERVO Lighted
HUMID HUMID Lighted
SLACK SLACK Flashes
Flashes Flashes Emitted
4 times 4 times 4 times The servo is
per per per out of order.
second second second
Emitted
4 times
Flashes
second
Lighted 4 times
*1)
Condensation
second
Continu-
ous
tone*2)
Flashes Flashes Continu-
4 times 4 times ous Tape wind-up
per per tone trouble
second second
VTR (section)
operation
Head clogging is
detected and a
warning tone
emitted. Images
may not be
recorded properly.
Recording
continues, but
images may not
be recorded
properly.
Recording
continues, but
stops if tape
sticking occurs.
Playback, fast
forward and
rewind operation
stops.
An error code
appears in the
time code display
position of the
display window
(LCD) and the
VTR stops.
Countermeasures
Clean the heads.
If images still
cannot be
recorded properly
after the heads
are cleaned,
consult your
dealer.
Turn off the power
and consult your
dealer. (Lamps
may flash briefly
and then go off
when tape running
starts, but this
does not indicate
trouble.)
If tape running
stops and the
HUMID display
does not go off
even when the
power is turned off
and then on again,
wait until the
display goes off.
Check the error
code in the display
window (see
page 127) and
consult your
dealer.
*1) During recording
*2) During playback, fast forward or rewind
<Note>
If a cleaning tape is not available to deal with video head clogging, etc., first estab-
lish the STOP mode and then press the STOP button again while the RESET but-
ton on the side panel is kept depressed. While these buttons are held down, the
cleaning roller will clean the heads for a maximum of 10 seconds.
- 1 2 5 -
Warning System
per
per