Panasonic AJ-D700P - Manual (Page 96)

Recording Simultaneously with the Internal VTR and an External VTR
Connections
Mount the AJ-YA700P 26-pin output adaptor (option) to the unit, connect the external VTR with
the 26-pin cable, and set the audio input level selector switch of the external VTR to “–60 dB”.
SW3101 and SW3102 on the CAM ENC Printed Circuit Board of the unit must be set to the 26P
side. (See page 98.)
Audio input level selector switch: –60 dB
Portable VTR
(Set the audio input level
selector switch to –60 dB.)
To the 26-pin connector of the AJ-YA700P
(See the following page for mounting the 26-pin
output adaptor)
Checking the Function Settings
Check that the settings of the functions which control the 26-pin interface are set to BOTH or ON
at the FUNCTION 3/5 page of the setting menu. See “Selecting Functions” for a description of the
various function settings.
Starting Recording
1
Operate the external VTR and set it to recording paused status.
2
Press the VTR START button of the unit or the VTR button of the lens. The internal and
external VTRs start recording simultaneously. Pressing the button again sets both VTRs to
the recording paused status.
If One VTR Comes to the End of its Tape During Recording
Even if one VTR comes to the end of its tape and stops, the other VTR continues recording oper-
ation.
Returning the VTRs to simultaneous recording status
If the internal VTR came to the end of its tape, replace the cassette and press the VTR START
button of the unit or the VTR button of the lens. The external VTR continues recording operation
during this time.
If the external VTR came to the end of its tape, replace the cassette and operate the external
VTR to restart recording. The internal VTR continues recording operation during this time.
<Note>
Care should be taken as the internal VTR will assume recording paused status if the VTR START
button of the unit or the VTR button of the lens is pressed after replacing the external VTR’s
cassette.
- 96 -