Panasonic AJ-D700P - Manual (Page 67)

3
Place the white pattern over a location with the same conditions as the light source illuminat-
ing the subject and zoom up to project white on the screen.
A white object (white cloth, white wall) near the subject can also be used. The white area
required is as shown below.
1/4 or more of the screen width
White cloth 1/4 or more of the screen height
<Note>
Take care not to allow high-intensity spots to
enter the screen.
4
Adjust the iris of the lens.
5
Press the AUTO W/B BAL switch to the WHT side and release the switch.
The switch returns to the center and the white balance is automatically adjusted.
AUTO W/B BAL switch
6
During the adjustment, the following message appears on the viewfinder screen.
(However, the message appears only when the display mode is set to “2” or “3”.)
AWB ACTIVE
Message during adjustment
7
Adjustment is completed after approximately 1 second (the following message appears) and
the adjustment value is automatically stored in the memory (A or B) selected in step 1.
AWB OK
Message after adjustment is completed
<Note>
If a lens equipped with the automatic iris function is used, the iris may experience hunting 1) . In
these cases, adjust the iris gain knob (the knob marked IG, IS, S, etc.) on the lens.
See the Handling Instructions for the lens for a detailed description.
1) Hunting: The auto iris responds repeatedly causing the image to become darker and brighter.
- 6 7 -