Panasonic DX-2000 - Manual (Page 100)

98
Direct Transmission
If your machine’s memory is full or you wish to send the document immediately, use Direct Transmission.
Manual Number Dialing (Direct Transmission)
To dial the telephone number manually, follow the steps below.
(see Note 1) (see Note 2) (see Note 3)
1
Set document(s) face down.
2
Make sure that the lamp goes off.
3 Enter a telephone number from the keypad.
Ex:
4
Your machine starts dialing the telephone number.
1. If you need a special access number to get an outside line, dial it first then press to enter a pause
(represented by a "-") before dialing the full number.
Ex : 9 PAUSE 5551234
2. If you are using Pulse dialing and you wish to change to Tone dialing in the middle of dialing, press
(represented by a "/").
The dialing mode will be changed from Pulse to Tone after dialing the digit "/".
Ex : 9 PAUSE TONE 5551234
3. To stop the transmission, press .
The display shows:
Press to stop the transmission. The Communication Journal will not print out regardless of the printout mode
setting of the Communication Journal.
ENTER STATION(S)
THEN PRESS START 00%
MEMORY
ENTER STATION
00%
5 5 5 1 2 3 4
PRESS START TO DIAL
5551234 ❚
START
* DIALING *
5551234
PAUSE
TONE
STOP
COMMUNICATION STOP?
1:YES 2:NO
1
Sending Documents via Telephone Line
Note: