Panasonic DX-2000 - Manual (Page 18)

16
Setup as POP3 Client
To install the DX-2000 as POP3 Client, the following network parameters need to be programmed on your
network.
• IP Address of the DNS Server (if not available, see Note)
• IP Address of the DX-2000
• Subnet Mask of the DX-2000
• Name or IP Address of the Default SMTP mail server
• IP Address of the Default Router
• POP Server Name or IP Address
• POP User Account Name
• POP Password
• Email Address of the DX-2000 (see Note)
(see Note 1) (see Note 2)
Email transmission (from the DX-2000 to a PC)
Email reception (from a PC to the DX-2000)
1. The email address format can be the same as your regular email address. If your email address is
[email protected], the DX-2000’s email address can be [email protected].
2. By default the machine requires the IP Address of the DNS Server and prompts you to enter the SMTP and POP
Server Names. If the DNS Server is not available, change the Fax Parameter No. 161 (DNS SERVER) to "1:Invalid".
Then the machine will prompt you to enter the IP Address of the SMTP and POP Servers.
[email protected]
SMTP01.panasonic.com
(SMTP Mail Server)
POP02.panasonic.com
(POP Server)
(Router)
[email protected]
SMTP
POP3
[email protected]
SMTP01.panasonic.com
(SMTP Mail Server)
POP02.panasonic.com
(POP Server)
(Router)
[email protected]
SMTP
POP3
Pre Installation Information
Note: