Panasonic KX-FC225NZ User Manual
Page 64
12. Help
64
12.3.3 Cordless handset
The ink film runs out quickly.
L
Even if there are only a few sentences, every page that comes out of the
machine is considered a full page.
L
Turn OFF the following features:
–
sending report: feature #04 on page 46.
–
journal report: feature #22 on page 47.
–
Caller ID list: feature #26 on page 48.
The base unit beeps.
L
The memory reception alert of feature #44 is ON (page 49), and the unit has
a document in memory. Press {STOP} to stop the beeps, then see the
displayed message instructions to solve the problem.
The speakerphone is not
working.
L
Use the speakerphone in a quiet room.
L
If you have difficulty hearing the other party, adjust the volume.
I cannot page a cordless
handset or base unit.
L
The cordless handset is too far from the base unit.
The unit does not display the
caller’s name and/or
telephone number.
L
You need to subscribe to a Caller ID service.
L
Other telephone equipment may be interfering with your phone. Disconnect
it and try again.
L
Other electrical appliances connected to the same outlet may be interfering
with the Caller ID information.
L
Telephone line noise may be affecting the Caller ID information.
L
The caller requested not to send his/her information (page 25).
L
If a call is being transferred to you, the caller information will not be
displayed.
L
For Australian users:
Your unit is connected to a telephone line with ADSL service. We
recommend connecting a filter (contact your ADSL service provider) to the
telephone line between the base unit and the telephone line jack.
For New Zealand users:
Your unit is connected to a telephone line with ADSL (JetStream) service.
We recommend that you contact your ADSL service provider to have an
ADSL Splitter installed. We do not recommend the use of generic ADSL
filters.
The display exits the Caller ID
List while viewing caller
information.
L
Do not pause for over 1 minute on the cordless handset or 3 minutes on the
base unit while viewing.
Problem
Cause & Solution
The cordless handset does
not work.
L
Make sure that the battery is installed correctly (page 15) and fully charge
it (page 17).
L
Clean the charge contacts and charge again (page 17).
L
Turn the cordless handset power OFF, then ON (page 17).
L
Check that the power cord is connected properly.
L
The cordless handset has not been registered to the base unit. Register the
cordless handset (page 55).
L
Re-install the batteries (page 15) and fully charge them.
The cordless handset display
is blank.
L
The cordless handset is not turned ON. Turn the power ON (page 17).
The cordless handset will not
turn ON.
L
Make sure that the batteries are installed correctly (page 15).
L
Fully charge the batteries (page 17).
L
Clean the charge contacts and charge again (page 17).
Problem
Cause & Solution
FC225-226AL-PFQX2518ZA-en.book Page 64 Friday, June 23, 2006 4:08 PM