Panasonic KX-FC225NZ - Manual (Page 67)

12. Help
67
A blank sheet is ejected. L If a blank sheet is ejected after the received document is printed out, the
size of the document sent by the other party is as large as, or larger than,
the recording paper, and the receiving reduction rate is not programmed
correctly. Program the proper rate in feature #36 (page 49).
L The other party placed the document in their fax machine facing the wrong
way. Check with the other party.
The printing quality is poor. Please do not reuse the ink film!
Please use genuine Panasonic replacement film. Refer to page 9 for further
details.
L The thermal head is dirty. Clean it (page 73).
L If documents can be copied properly, the unit is working normally. The other
party may have sent a faint document or there may be something wrong
with the other party’s machine. Ask them to send a clearer copy of the
document or to check their fax machine.
L Some paper has instructions recommending which side to print on. Try
turning the recording paper over.
L You may have used paper with cotton and/or fibre content that is over 20%,
such as letterhead or resume paper.
Recording paper frequently
misfeeds. L Clean the document feeder rollers, recording paper feeder and rubber flap
(page 72).
Letters on the received
document are distorted. L If your line has special telephone services such as call waiting, the service
may have been activated during fax reception. Connect the unit to a line that
does not have these services.
I cannot receive documents
using the cordless handset. L The memory is full of received documents due to a lack of recording paper,
a lack of ink film or a recording paper jam. Install paper (page 15), install ink
film (page 13) or remove the jammed paper (page 70).
When an extension telephone
is connected, I cannot receive
documents by pressing
{*}{#}{
9}.
L You must set remote fax activation to ON (feature #41 on page 49)
beforehand.
L You may have changed the remote fax activation code from {*}{#}{9}
(default setting). Verify the remote fax activation code (feature #41 on page
49).
L The memory is full of received documents due to a lack of recording paper,
a lack of ink film or a recording paper jam. Install paper (page 15), install ink
film (page 13) or remove the jammed paper (page 70).
The other party complains
that they cannot send a
document. L The receiving mode is set to TEL mode. Receive the document manually
(page 34) or change the receiving mode to TAM/FAX mode (page 36) or
FAX ONLY mode (page 36).
L The memory is full of received documents due to a lack of recording paper,
a lack of ink film or a recording paper jam. Install paper (page 15), install ink
film (page 13) or remove the jammed paper (page 70).
I cannot select the desired
receiving mode. L If you want to set TAM/FAX or FAX ONLY mode:
–
select the desired mode using feature #77 (page 51), and press {AUTO
ANSWER} repeatedly until the desired mode is displayed.
L If you want to set TEL mode:
–
press {AUTO ANSWER} repeatedly to select TEL mode.
L The Distinctive Ring is set (feature #31 on page 38).
Problem Cause & Solution
FC225-226AL-PFQX2518ZA-en.book Page 67 Friday, June 23, 2006 4:08 PM